|
Dude Plur is right on with the amp, you have an amp that claims 750 watts x1 at a 2 ohm load if you could find a way to wire up 10 subs at 2 ohms each one would be getting 75 watts, if you wire one 2 ohm sub to it that one sub would get 750 watts. you have to plan this stuff out. This is all assuming that amp is really putting out those watts. As far as the 80 amp fuse i personally don't think you're ever going to pull that amount of juice, I run Zapco amps, and my 500 watt sub amp is only pulling 40 amps max, I don't think (if you are actually getting 750W RMS/clean you would be pulling more than 60-65.)
I will disagree with any advice on a cap, but those arguments never go well on a forum. Spend the money on a better battery instead.
now back to the OP sure you can do it-tap the rear wires to a Line output. . .but why? if you have the stock 4 speaker setup anything you do is going to make it sound better, rip it out man and start over! the stock speakers are awful and the deck isn't any better.
Last edited by cpik; 02-27-2008 at 09:08 PM.
Reason: i can't spell
|