|
|||||||
| Interior & Exterior Styling Talk about interior and exterior products such as body kits, spoilers, steering wheels, shift knobs, etc. |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
|
|||||||
| Interior & Exterior Styling Talk about interior and exterior products such as body kits, spoilers, steering wheels, shift knobs, etc. |
|
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
03-05-2008, 05:02 PM
|
|||
|
|||
|
nahh i havent seen any ...i know VIS and SEBON are teo brnds of Carbon Fiber Companies if you wanna contact them
__________________
 Mod's So Far: AEM CAI, Tinted, Totally Debadged, Custom front SS bumper, Lower Billett Grille, DC Carbon Strut Bar, 2.5 Magnaflow Catback Exhaust and dropped on Progress Springs. Future Mods: In Order - Rimmies, Intake Mainfold Swap, Drilled and Slotted Rotors, Trans Mounts, Short Throw Shifter, Internals, Ingalls Stiffy Torque Dampner 
|
|
03-05-2008, 05:06 PM
|
||||
|
||||
|
Bigred .. I can get them made for you .. they aren't cheap though .. take a look at RacingSolution.Com - Chevy Cobalt Aftermarket Parts .. PM me which kit you like
__________________
 
|
|
03-05-2008, 07:14 PM
|
|||
|
|||
|
sweet bro. I'm looking for the SS front bumper valance, side skirts, and rear bumper valance. Can you give me an estimate?
bigred07 added 3 Minutes and 40 Seconds later... thanks =) Last edited by bigred07; 03-05-2008 at 07:18 PM. Reason: Automerged Doublepost
|
|
03-05-2008, 07:32 PM
|
||||
|
||||
|
Can't get those... If you want a full carbon bumper, I can make one from any of the front bumpers on Scion xA,Scion xB, Scion tC,Carbon Fiber Hood,Lip Kit,Body Kit ..
__________________
|
|
03-06-2008, 05:52 AM
|
||||
|
||||
|
Could you get the bomex kit in carbon fiber?
dkanderson added 0 Minutes and 32 Seconds later... or just the ones from racing solution?
__________________
 mods: eibach sportlines springs- GMPP SRI, TWM short throw- 2.25" Custom exhaust (except headers) Dual resonators (1 inplace of cat, 1 in middle of exhaust) flowmaster race muffler (about 14" from tip to tip) 4" magnaflow tip- gen1 halos- 5% tint- blacked out wheel caps- under-dash blue neons- one 10" MTX Jackhammer with 1200watt 2channel sony amp Last edited by dkanderson; 03-06-2008 at 05:53 AM. Reason: Automerged Doublepost
|
|
03-06-2008, 07:54 AM
|
||||
|
||||
|
Only the ones from racing solution
$650 for a full carbon fiber front bumper + shipping .. I told ya it would be expensive  but it uses a LOT of carbon fiber to make a full bumper
__________________
|
Linear Mode
