Chevy Cobalt Forum banner
Status
Not open for further replies.

Bandana Shift Boot

3K views 5 replies 4 participants last post by  agita_san 
#1 ·
are there any diy on this topic?
 
#5 ·
I've made a few shift boots out of different things. Basically you need to cut 4triangles of cloth. 2 triangles wide enough at the bottom to fit your shifter from top to bottom, and 2 triangles wide enough at the bottom to fit it from side to side at the base. They will all need to be about 10 inches tall each, and about 1 inch wide at the top. Sew them together while inside out so the stitching is hidden, and you are good to go...
 
#6 ·




Here's some of the shift boots I've made. The installed pic was in my ride and the hello kitty and my little pony ones were made for a couple of friends...
 
Status
Not open for further replies.
You have insufficient privileges to reply here.
Top