Chevy Cobalt Forum banner

Status
Not open for further replies.
1 - 11 of 11 Posts
J

·
Guest
Joined
·
0 Posts
Discussion Starter #1
Do you need to pull the exhaust manifold to replace this on the 2.2L motor?
 

·
Registered
Joined
·
2,969 Posts
Not sure on 2.2 but on my 2.4 I had to just to get a good grip on it

---------- Post added at 12:52 PM ---------- Previous post was at 12:51 PM ----------

Ur thermostat broken or u adding a gauge
 
J

·
Guest
Joined
·
0 Posts
Discussion Starter #6 (Edited)
Never mind. The stealer-ship wants $125.00 to do it.... so they will be doing it. I don't have the patience to deal with it. I just don't understand why they put it where they did.
 

·
Registered
Joined
·
490 Posts
Never mind. The stealer-ship wants $125.00 to do it.... so they will be doing it. I don't have the patience to deal with it. I just don't understand why they put it where they did.
Lets see half and hour of work = $60, $40 dealer thermostat, $25 gasket.
 

·
Registered
Joined
·
79 Posts
"I'm sorry sir, I know we were only supposed to replace your thermostat but it's gonna cost an extra $5,000.00. We somehow managed to notice/break your tie rod ends, then their is an allignment, plus the cost of disposal, not to mention the wireharness we chopped in half, and your manifold wasn't shinny so thats gonna cost ya too, oh and you did want your interior replaced right?"

Screw the stealership, go to bed early, wake up rested, and take half an hour to do it yourself.
 
1 - 11 of 11 Posts
Status
Not open for further replies.
Top