Chevy Cobalt Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
I recently replaced the clutch which involved taking the motor partly off. Right after everything was back together I put my battery back in and nothing, no dash lights or anything. I jumped it from the front and it had a hard time but eventually started up, if I try to jump it from the back, it doesn’t work at all. It is a brand new battery and I checked the fuses aswell. I’m kinda stuck here and don’t know what to do, any suggestions would be appreciated. Also it’s a 2.2 manual
 

·
Registered
Joined
·
743 Posts
Seems you may need remove and clean the terminals to the jump start post at the under hood fuse box. Check them again. That cable (at the fuse box) goes straight from the battery in the trunk to the starter with the junction at the fuse box. Now I am assuming the connections at the starter and at the battery are verified and known good. This leaves the jumper post and the connections there.. a little scotch bright followed by good old faction grease or silicon grease .
 
1 - 2 of 2 Posts
Top