Joined
·
1 Posts
Hello I just installed AC in a non AC car using the wires from the donor car (5) but my car doesn't give power to the compressor. Do I need to install the body module off the donor car as well?
2010 Ac install
Join the discussion
Recommended Reading
-
car won't run
Forum FAQ's and How-to's (READ FIRST)2006 cobalt 2.4 lt Car was working fine. stopped and got gas ,10 minutes later car shuts down. Pulled over tried to restart. cranks over but will not start. car will run with carb cleaner but not gasoline. fuel pump is working. replaced mass air flow sensor. ecm. ignition switch. plugs ,coil...- 0
- 29
-
maillady · updated
-
Oil Change
Forum FAQ's and How-to's (READ FIRST)So I bought a 2008 Cobalt, and I have to do my first oil change. I commute to work 50 miles each way, so I wanna make sure I take that into consideration when selecting my oil and filters. Any suggestions for me?- 2
- 166
-
P0341 Issues AGAIN
Forum FAQ's and How-to's (READ FIRST)So, I have been having problems with my 2009 Colbalt again. I keep getting the CEL coming on and its telling me that it is P0341 code for the CPS. I have replaced the CPS 3 times already this year. I am at my wits end trying to figure out what the problem actually is. I have cleaned out where...- 0
- 73
-
How to repair temperature blend door shaft
Forum FAQ's and How-to's (READ FIRST)In this how to, I'm going to show you what I did to fix my temperature blend door shaft after the actuator sheared it clean off. I do not take any credit for this because I only followed other guides on various different websites including this one, but there were no photos to reference so I'm...- 3
- 117
Join now to ask and comment!