Chevy Cobalt Forum banner

Status
Not open for further replies.
1 - 20 of 24 Posts

·
Banned
Joined
·
7,805 Posts
Discussion Starter #1
Jared
Western PA
Front control arm bushings the non hockey puck ones
Just so you know these are a pain in the ass to install on the control arms. I've given up trying to put them in so they are for sale for dirt cheap if anyone wants them. $15 shipped.
 

·
Registered
Joined
·
745 Posts
this is an amazing deal. if i had a job i'd buy them just to have backup ones. i have the prothanes installed already.

if it helps, i took an aceytelene torch (or however you spell it) and torched the old bushings til they were like marshmellows and then scraped and cut them off that rod theyre bonded to. got both sides done in half hour.

---------- Post added at 10:43 AM ---------- Previous post was at 10:41 AM ----------

actually pm'd
 

·
Banned
Joined
·
7,805 Posts
Discussion Starter #11
mike and chris didn't want to burn the old ones off

---------- Post added at 07:13 PM ---------- Previous post was at 07:13 PM ----------

mike and chris didn't wanna burn the old ones off
 

·
Registered
Joined
·
1,969 Posts
i think using a propaine torch will burn them out better than using brake cleaner and a lighter
 
1 - 20 of 24 Posts
Status
Not open for further replies.
Top