Chevy Cobalt Forum banner

Status
Not open for further replies.
1 - 13 of 13 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter #1
Ive had my coablt for 3 years now. Just completed my front end repair new lowering springs, strut mounts, lca bushings and end links- what a p.i.t.a.. like the car but those original end liks took forever. injen cai and now wanting to do exhaust cat back, cant figure out what one to put, I dont want to sound like a fart can would prefer lower rumble.
 

·
Wootsauce!
Joined
·
8,593 Posts
Welcome!


Tip on the endlinks: Put a 17mm open end wrench on the backside of it and you can hold it from spinning while trying to remove the nut. Air tools help also.

Exhaust: Magnaflow
 

·
I cut stuff
Joined
·
6,238 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter #4 (Edited)
used air tools, had to gring em out, jobs done took a few hours for one side then 1.5 hours for the other side.

as to the exhaust i kinda of like the sound of the flowmaster, i really like the sound of the n1 muffler but those are youtube vidz
 

·
Premium Member
Joined
·
787 Posts
welcome to the site
 

·
Registered
Joined
·
3,229 Posts
I would say check the GMPP exhausts out. They sound sick and look good too! and they're def. not ricey :D
 

·
Say What again!
Joined
·
6,037 Posts
Welcome to the site!
 
1 - 13 of 13 Posts
Status
Not open for further replies.
Top