Chevy Cobalt Forum banner

Status
Not open for further replies.
1 - 20 of 28 Posts

·
Say What again!
Joined
·
6,033 Posts
I think a low-rise in the back would help that scheme. Oh, and a drop - but from what I see it looks good.
 

·
Registered
Joined
·
446 Posts
Cream on the inside!
Clean on the outside!

lol. Looks really clean though.
 

·
Get Out The Sawzall
Joined
·
1,856 Posts
Looks great, if I may add a suggestion I would say lower it and add an accent stripe to seperate the black and white.

This is what I want to eventally do except my balt is silver, so I am going to keep the silver on the bottom, add a dark graphite on top and a red 1/4 inch stripe to seperate the two.
 

·
Registered
Joined
·
3,229 Posts
damn that's some skill right there! where did you do this? and i'm assuming you used a decent paint gun? good job taping everything off. was it hard to tape it all evenly? looks pretty chill, now lower that bad boy???
 

·
Registered
Joined
·
109 Posts
Discussion Starter #15
tHanks guys I know I still need a drop
I'm taking auto body and had a chance to work on my car not to sure on the gun I used was the instructors but being a student I got a discount with our supplier so total cost for this job was $108.
Not to sure on my accent stripe probbaly gonna go with lime green
 
1 - 20 of 28 Posts
Status
Not open for further replies.
Top