Chevy Cobalt Forum banner

Status
Not open for further replies.
1 - 4 of 4 Posts

·
Registered
Joined
·
10 Posts
Discussion Starter #1
hey whats up everyone.. My cobalt is the ls model and I was thinking about adding some power windows and power locks to it.

My question is since the car didn't come pre-stocked with these options, is the wiring already in place under the door panel and so all I would have to do is hook them up? Or would I have to by the modulators and everything plus do all of the wiring?

Roughly how much would it cost to take my car somewhere and have it done?
 

·
Registered
Joined
·
2,724 Posts
There's no wiring or anything, I had my power windows installed for $250 and ive had them for about 3 years. Only problem I had was a bad ground (Installer choose a terrible location). As for power locks I only have 2 doors so I thought it was pointless.
 

·
Registered
Joined
·
10 Posts
Discussion Starter #3
hey whats up... I got your reply to my post on the power windows, thanx for that. Quick question... when you have it done somewhere like you did, what do they do whit the holes where the cranks were? And also where do they install the power buttons for the windows?
 

·
Registered
Joined
·
2,724 Posts
hey whats up... I got your reply to my post on the power windows, thanx for that. Quick question... when you have it done somewhere like you did, what do they do whit the holes where the cranks were? And also where do they install the power buttons for the windows?
They put the power window buttons right over my holes.

Ill post a pic.

 
1 - 4 of 4 Posts
Status
Not open for further replies.
Top