Chevy Cobalt Forum banner

Status
Not open for further replies.
1 - 5 of 5 Posts

·
Registered
Joined
·
248 Posts
Discussion Starter #1 (Edited)
okay u know how the wires connect to the speaker (rear speaker)???

well i followed the "how to install subs on stock head unit" thread and when i cut the wires i cut it too close to the speakers and now i dont have room to splice them...

i saw that the wires connect to a wire harness thing i guess...i think...but i need to buy one of those but i need to know what it is called


HELLLLPPP need to know b4 it gets to dark outside


u can see what im talking about on the second and third pic here http://www.yourcobalt.com/forums/install-guides-diy/10807-how-install-system-stock-head-unit.html#post187450

---------- Post added at 04:16 PM ---------- Previous post was at 04:05 PM ----------

come on now...bump
 

·
Registered
Joined
·
821 Posts
solder and soldering iron? but u cant do that upside down.... stupid gravity
 

·
Registered
Joined
·
294 Posts
take a pic of what you did to yours and it'd be easier to assist you in solving the problem
 

·
Registered
Joined
·
248 Posts
Discussion Starter #5
i love best buy...went there and the as soon as i described my problem they knew what i was talkin about...it is a general motors speaker harness wire (this one is only for GM), but yah they gave me the product, went to check out pulled out my money...annnnndd was 2 dollars short

the damn thing costs 13 dollars


here is what i needed..
 
1 - 5 of 5 Posts
Status
Not open for further replies.
Top