[culby218]

OK so i just out on my tsudo exhaust and i kind of forced it up to the hangers to get it to mount and i drove 45 mins to my house from my dads and when i got out of the car my back bumper is starting to melt i know someone on here said some minor modification required to get it to hang right if someone can help me asap that would be great since i no longer have a stock exhaust

 

[Cherry GT]

My magnaflow system came with a different
hanger for the rear. Might be what you need.
Local parts store or exhaust shop should have
some hangers depending on where you live.

My tip is real close to the bumper, but have
never had any melting issues for two years.

 

[cobaltkrazy]

OK so i just out on my tsudo exhaust and i kind of forced it up to the hangers to get it to mount and i drove 45 mins to my house from my dads and when i got out of the car my back bumper is starting to melt i know someone on here said some minor modification required to get it to hang right if someone can help me asap that would be great since i no longer have a stock exhaust

Take it to an exhaust shop, have them alter the hangers to make it fit right. If you had to force it into place, then you know it's not the right fit, and will need to be modified

 

[Chester]

My magnaflow system came with a different
hanger for the rear. Might be what you need.
Local parts store or exhaust shop should have
some hangers depending on where you live.

My tip is real close to the bumper, but have
never had any melting issues for two years.

Got a couple of pics ?

 

[Cherry GT]

pics of tip or hanger ?
hanger was just the same as stock
only just a little bit longer.

 

[ssnick]

You could try getting some heat wrap and put on their too. I know autozone, checker, etc... sell a wrap for headers, don't see any reason you can't put some heat wrap between your exhaust and your bumper. It would be a temporary fix until you could get under there or take it in and get the hangers modified.