Joined
·
35 Posts
i guess you can call me new, name is David and i drive a 2008 1LT with some mods(look in my sig). here some of the ride
New guy
- Status
1 - 10 of 10 Posts
Joined
·
384 Posts
welcome
Joined
·
35 Posts
Thanks
Joined
·
1,333 Posts
Welcome
Joined
·
73 Posts
welcome
Joined
·
13 Posts
Welcome to the forum
1 - 10 of 10 Posts
- Status
Join the discussion
Recommended Reading
-
Newbie
New Member IntroductionsWe've had our 06 cobalt since it was new and so far it's been the most reliable car we've had although I've had to replace the front lower controls arms to deal with persistent control arm bushing issues but today it quit with the code scanner showing P0601. I've already posted a question on...- 0
- 25
-
Newly Purchased Chevy Cobalt 2019 and here's my experience
New Member IntroductionsHi Everyone, I recently joined Your Cobalt after knowing about this forum based on my new Chevy Cobalt. Well Honestly speaking I am 2nd owner of my Chevy Cobalt but it's a new car for me because it's my first car. I purchased it because of it's fuel efficiency and decent power to get me for my...- 1
- 300
-
Vickymrogers · updated
-
No Cobalt but putting a 2.2 ecotec in a baja bug
New Member IntroductionsI am looking for information and know how. I am building a baja bug and the air cooled engine costs too much money to get less then I can get out of an ecotec 2.2 in every way. I picked the ecotec 2.2 over subaru for the low end torque. I picked this engine up for 300 dollars. I got it with the...- 1
- 42
-
09 Cobalt Headlights (low and high beams) not working
New Member IntroductionsHello, after a few days of heavy rain my 2009 cobalt decided to have some tech issues. Headlights were working, so I switched to my high beams which worked for a few minutes then stopped working. A day later while I was listening to the radio, went to ten the volume and it started acting up...- 1
- 187
-
Mycobalt2009 · updated
-
2006 cobalt lt 2.2 coolant in the oil
New Member IntroductionsI have been installing a water pump and head gasket on my cobalt. When I crunk it up to test it out, it ran fine for a few minutes and started slightly shaking. I removed the valve cover and noticed a little bit of milky oil on the bottom of valve cover. I tried a wet and dry compression test...- 0
- 117
Join now to ask and comment!