Chevy Cobalt Forum banner

Status
Not open for further replies.
1 - 1 of 1 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter #1 (Edited)
ÅHello everyone , I'm new to the Chevy family yet alone Cobalt. I just purchased a 2006 chevy cobalt ls and today I have been soley working on installing my subs and aftermarket radio. I have all wires connected except the accessory 12v red Wire. The radio displays normally when I press eject disc breifly before going black again. When I press info the time displays and then goes black after a few secs. I have researched extensively just to run into another road block, alot of people's answers were simply run the accessory Wire to the sunroof fuse which is not in use currently. I've only been able to find 2-10a fuse taps so far and believe I need a 15a tap since the sunroof fuse takes 15a? And by my radio only illuminating when the eject button or info button is pressed, do you think this has everything to do with my accesory 12v not being hooked up properly?
 
1 - 1 of 1 Posts
Status
Not open for further replies.
Top