Chevy Cobalt Forum banner

Status
Not open for further replies.
1 - 11 of 11 Posts

·
Registered
Joined
·
435 Posts
Discussion Starter #1
I just wanna get a new rim as the one in the rear driver side is bent in the upper trim. It's the 2LT 16" 5-spoke 5 lug edition. Here's the pic of the factory one to see if it matches because the site mentioned machined faced or chrome. I believe I have machined faced.

Wheel A-05269U10, 2010 CHEVY COBALT Wheels COBALT Rims

I'n not interested in aftermaket rims because I like the 16"s. Though I wouldn't mind the G5 GT 17"s :)
 

·
Registered
Joined
·
1,060 Posts
^^^^^^ Same.... Question??? I do have a set of G5 GT oem 17's for sale if interested.

423
 

·
Registered
Joined
·
435 Posts
Discussion Starter #4
It's funny but the question Is my car have the machined finish 16" wheels or the chrome? Looking at my rim it looks hybridish lol.
 

·
Registered
Joined
·
435 Posts
Discussion Starter #6
Ok so I decided to make this a backup plan as theres a wheel repair place in St. Pete, FL. Any idea the quote on unbending the rim trim?
 

·
Say What again!
Joined
·
6,037 Posts
They didn't make chrome 16s that I'm aware of.
 

·
Registered
Joined
·
141 Posts
They didn't make chrome 16s that I'm aware of.
u had to custom order them from gm but other then that no they didnt
 

·
Registered
Joined
·
1,218 Posts
The G5's version of it will work. Same wheel, different cap.
 

·
Registered
Joined
·
435 Posts
Discussion Starter #11
I just got back from having the rim repaired. About $200 but so far rides good, no TPMS light. Seems the rim had 2 bends (outer lip, inner lip).

However I might consider getting the G5 GT wheels on that site. :)
 
1 - 11 of 11 Posts
Status
Not open for further replies.
Top