Chevy Cobalt Forum banner

Status
Not open for further replies.
1 - 5 of 5 Posts

·
Registered
Joined
·
210 Posts
Discussion Starter #1
Is the plasti pin removed when adding installing a short shifter reusable? Of course my dads wife threw it away with my lugnuts. I'm not ordering one from a dealer, or paying for another shifter just for that. I'll go get a peice of metal and cut it to work if i have to, but i guess nothing is safe with the hoarder around. Ugh
 

·
Registered
Joined
·
210 Posts
Discussion Starter #3 (Edited)

·
Registered
Joined
·
210 Posts
Discussion Starter #5
Yep. Put back together too. Careful removing of the pin kept it intact, but if its strong enough is the question. Its tight so it should be fine, but i will see. Lol

---------- Post added at 06:51 PM ---------- Previous post was at 06:44 PM ----------

Only question now, is how far do i push the cables back into the clip attached to the shifter? Is this the adjustment thing that takes trial and error. Damn i should have paid more attention when taking it apart. Lol

---------- Post added at 08:30 PM ---------- Previous post was at 06:51 PM ----------

Done. Hardest part was putting the new boot on to my satisfaction, and figuring out how to get my $15 autozone shift knob back on. Which will have ti be replaced since the allens stripped out. But the pvc pipe around the shifter works pretty good at widening out the threaded part to fit the knob. Pics tomorrow, since its dark and i'm watching my dad who is all messed up on percocet, zanax, and idk wtf else. All prescribed since he had brain surgery, but still very funny.....
 
1 - 5 of 5 Posts
Status
Not open for further replies.
Top