Chevy Cobalt Forum banner

Status
Not open for further replies.
1 - 6 of 6 Posts

·
Registered
Joined
·
168 Posts
Discussion Starter #1

·
Registered
Joined
·
379 Posts
Shiny!

Looking good so far. I would polish up that valve cover to compliment that intake.

I would actually like to see a pic of the car from behind, just to see how big that exhaust tip is. Don't go too big on the tip or else it looks like rice IMO.
 

·
Registered
Joined
·
168 Posts
Discussion Starter #4 (Edited)
Shiny!

Looking good so far. I would polish up that valve cover to compliment that intake.

I would actually like to see a pic of the car from behind, just to see how big that exhaust tip is. Don't go too big on the tip or else it looks like rice IMO.
in the engine mods section theirs a pic of the exhaust
jkk i put that pic in wrong section ill get one up in a second

---------- Post added at 10:57 AM ---------- Previous post was at 10:54 AM ----------

Imageshack - dsc00639v.jpg
 

·
Registered
Joined
·
379 Posts
From that angle it looks like it sticks out too far for my liking, but in the first pic the length looks fine. :huh:

The diameter is about as big as I'll tolerate before I start yelling "RICE!"

Personally I think it would look better if it was just a bit narrower, but other than those two things, it looks good.
 
1 - 6 of 6 Posts
Status
Not open for further replies.
Top