Chevy Cobalt Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter #1
Long story short, I bought all the parts to replace/upgrade my fron suspension and then got hurt befpre i could get everythong replaced. This last weekend i finally got to tearing down the front end and putting it back together. However when trying to install the new front hubs i couldn't get them to seat properly in the front knuckle. They havr a slight raise ridge that's abput 2 mm tall. Wont let the hub completely come up to the knucle tk get the bolts on. Everythong seems identical minus this little ridge. Did i get the wrong ones? I almost though about trimming part lf tgw knuckle to get the hub to seat all the way down. Bad odea? Exchanging the hubs it out of the question so i just gotta make what i gave work so I dont havw to eat the cost of these hibs i already got.
 
1 - 2 of 2 Posts
Top